Energetic Spring Steel Sheet 350x350mm for Voron 2.4 - One side PEI powder coated textured
With this flexible printing pad, the days of spatulas and the like are finally over. Simply remove the plate from the print bed,
bend it and the print is released.
Due to the powder coating, this surface is particularly good for filaments (such as TPU, TPE, ASA , PETG, CPE and many more) which can damage the regular smooth PEI surface due to their high adhesive force. Furthermore, the texturing gives your prints a whole new look.
More suitable for certain filaments (TPU, TPE, ASA, PETG, CPE)
Scratch resistant, difficult to damage
transfers texture to the bottom of the print
Forgive first layer settings errors.
Better first layer
Flexible and detachable
Easily remove the print - After it cools down, just bend the plate a little and take it off the print
Note on using the powder-coated PEI surface:
Do not use acetone for cleaning!!! This will damage the surface and, after a short time, will cause the coating to peel off.
When removing the print, please ensure that the plate has cooled down completely.
Otherwise you risk damaging the disk
Scope of delivery:
1x spring steel sheet 350x350mm with PEI powder coating on one side
Magnetic plates option:
If you don't have a magnetic print bed, there is also the option to buy a magnetic plate.
The big advantage of this magnetic plate is the high temperature resistance of 140°C.
Most cheap plates lose their magnetic properties at temperatures above 85°C. The plate is equipped with a 3M adhesive film on one side.