Energetic Spring Steel Sheet 120x120mm Voron V0 V0.1 - Single sided PEI textured
With this flexible printing pad, the days of spatulas and co. are finally over. Simply remove the plate from the print bed,
bend it and the print is released.
The powder coating makes this surface particularly good for filaments (such as TPU, TPE, ASA , PETG, CPE and many more),
which can damage the regular smooth PEI surface due to their high adhesive force. In addition, the texturing gives your prints a whole new look.
More suitable for certain filaments (TPU, TPE, ASA, PETG, CPE)
Scratch-resistant, hard to damage
Transfers texture to the bottom of the print
Forgive mistakes in setting the first layer.
Better first layer
Flexible and removable
Easily remove the print - after cooling, just bend the sheet a little and take it off
Note on using the powder-coated PEI surface:
Do not use acetone for cleaning !!! This damages the surface and after a short time causes the coating to peel off.
When removing the print, please make sure that the plate is completely cool.
Otherwise you risk damaging the plate.
Scope of delivery:
Magnetic bed option:
If you do not have a magnetic print bed, there is also the option to buy a magnetic plate.
The big advantage of this magnetic disk is the high temperature resistance of 140 ° C.
Most cheap plates lose their magnetic properties at temperatures above 85 ° C. The plate is equipped with a 3M adhesive film on one side.