Shake the bottle.
Apply to the desired area by pressing the nib on the bed (activating the inner valve) and spreading as needed.
Print according to the filament/printer manufacturers recommendations
Allow to cool and Remove. The print should pop right off
Clean - Use a damp cloth to wipe off.
SAFETY:Using this product with other than Flexible type filaments might cause over adhesion and damage your build surface.
Important note : The applicator has an active spring valve, which activates when applicator is pressed against the build plate. Please do not press the bottle as "ketchup bottle" , otherwise the applicator may pop off. Bottle may be slightly squeezed, only when the nib is pressed against the bed and it may be necessary only if bigger flow is required. Bottle must not be squeezed when cap is off any other time as it may result in glue popping out of the bottle.
There are no reviews yet.