Energetic Spring Steel Sheet for Prusa MK4 / MK3s / MK3s+ - PEI Smooth / Powder Coated
With this flexible printing underlay, the days of spatulas and the like are finally over. Simply remove the plate from the printing bed,
bend it and the print is released.
The use of high-quality spring steel means that this printing pad is always perfectly flat and does not warp when heated.
(Assuming you have a print bed with magnets.)
Smooth PEI surface:
Only high quality PEI made in Europe is used for the panel. This ensures a uniform layer thickness and good adhesion.
Features smooth PEI surface:
-
No warpage
-
Better first layer
-
Flexible and removable
-
Suitable for a wide variety of filaments.
-
Easily remove the print - after cooling, just bend the sheet a little and take the print off
-
PEI is already applied with 3M adhesive tape.
Note on using the smooth PEI surface:
When printing PETG / PCTG / TPU / ASA please use a separator (e.g. Magigoo), because The adhesive force of these materials in connection with PEI means that the material bonds permanently to the pressure plate.
When removing the prints, please make sure that the plate has cooled down completely.
Otherwise you risk damaging the plate.
Powder-coated PEI surface
The powder coating makes this surface particularly good for filaments (such as TPU, TPE, ASA, PETG, CPE and many more),
which can damage the regular smooth PEI surface due to their high adhesive force. In addition, the texturing gives your prints a whole new look.
Features powder-coated surface:
-
More suitable for certain filaments (TPU, TPE, ASA, PETG, CPE)
-
Scratch-resistant, hard to damage
-
Transfers texture to the bottom of the print
-
Forgive mistakes in setting the first layer.
-
No warpage
-
Better first layer
-
Flexible and removable
-
Easily remove the print - after cooling, just bend the sheet a little and take it off
Note on using the powder-coated PEI surface:
Do not use acetone for cleaning !!! This damages the surface and, after a short time, causes the coating to peel off.
